![]() ![]() I found out the pro or pro mini is not the same as the pro trinketīut what happened to the trinket in the board menu, it is not there.I checked the 1.6.7 version, but also tried the 1.0. After a while the IDE reports not in sync with code 0x5d, but I have seen several other codes as well The red light stops flashing, goes red for a while (>1sec) and then starts flashing again, repeating this sequence. Then I try it with a prolific FDTI cable (which I also use with the HUZZAH) and select in the IDE COM4 which is the right device. For some reason in the IDE it states COM1 as port, I can not deselect that and after a while I get the sync error 0x30 or 0x87., Each time I try it is a different code. Then I try to upload the blink example program. In the windows device manager is see the USBtiny device come up. Now I try connection the trinket with a normal mini-USB cable. ![]() I choose the board: Arduino pro or pro mini, I guess that is right but the menu doen't match the 1.0.5 IDE where the trinket is a separate option. Just follow the steps in the Adafruit Arduino IDE setup guide to add Adafruit board support to the Arduino IDE to program Pro Trinket Dont forget to also. ![]() I recently bought a pro-trinket 5V and am trying to conenct it to PC. (32x the Flash, 64x the RAM, 6x faster processor.) It can be used with Arduino IDE or CircuitPython. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |